Hi,
Every time I change the delay mix setting, in this case from 7 to 4, mod delay, in PC editor, then write it, when I switch patches and go back to the patch it is still at 7. The same thing happens when I do this in the file tab and update the patch: it goes back to 7 after switching back and forth between patches.
I have tried removing and reinstalling the PC editor to no avail.
Can someone help.
Thanks
Have you saved it on the
Tue, 2008/06/17 - 2:11pm — firebrandHave you saved it on the editor or saved it on the TL ?
I think what Fire means..
Wed, 2008/06/18 - 3:12pm — mself61I think what Fire means.. when you save the setting (write current program) then from "FILE" save it, it will save to the file you are working on, if you are working from the tab "ToneLabSE" dump, then you do the same but to make sure also use the WRITE button on the TL itself, then save again from the editor.
www.selfdistruction.com
http://groups.google.com/group/tonelab-patch-exchange
Hi all.. I have a EDIROL UM
Tue, 2008/06/24 - 8:21am — DronJesHi all..
I have a EDIROL UM 1EX Roland Midi to USB Interface, it was working fine and had uploaded a number patches to the SE, however I took the Se to a mates place a couple of times, and we had tweaked a couple of sounds to better suit our needs, however upon plugging the MIDI Cable into the SE, the Tonelab Editer Software says that a 'MIDI Communication Error occured and to check the cables and interface' I have reloade dthe software and have run out of options, and suggestions.
you probably have to re-set
Tue, 2008/06/24 - 7:00pm — mself61you probably have to re-set your MIDI in out in the editor.
if not let me know.
www.selfdistruction.com
http://groups.google.com/group/tonelab-patch-exchange
I have found it helps to
Wed, 2008/06/25 - 5:29am — firebrandI have found it helps to have everything connected then turn on the computer. This way the MIDI device is "native" when your OS boots and you start the editor.